GPS Installation App Tests and Documentation

1 GPS Installation Smartphone-App
2 Start screen of the GPS Installation App:
3 Enter one-time password
4 Search for devices
5 Check the test data
6 Checklist for fixed Installations
7 Mandatory (absolutely necessary):
8 Depending on the customers configuration::
9 Documentation

If you have troubles during the installation, your workshop shall contact our support via phone.

GPS Installation Smartphone-App

There is a new smartphone app for workshop and customers that want to install and test GPS tracking devices.

https://proddataserver.sw-management.at/BoxServer/ws/login

Start screen of the GPS Installation App:

Click on Login to enter your access codes (one-time passwords). You will get the one-time passwords from your customer (GPS Fleet Software administrator).

Enter one-time password

The one-time password is valid for one asset, one customer-account or all devices of a partner.

Search for devices

Enter the IMEI or part of the IMEI or the asset name below and click on search.

Check the test data

Check the GPS Installation App test data:

The time mustbe correct
DI1 must be checked, if you activate the ignition and unchecked, if you swith off the ignition
Address and position must be correct
e.g. DI2 must show the state of other connected senosts
the field ibutton input must contain the of the driver

Checklist for fixed Installations

Mandatory (absolutely necessary):

Before beginning the installation of your product, qualified personnel (skilled in electronic/electrical installation) must read completely this guideline (absolutely necessary)
Check the correct position of the GPS Antenne (absolutely necessary)
Check, if the device has permanent power (absolutely necessary)
Check, that ground is connected correkly (absolutely necessary)
Check that the ignition is connected correctly (absolutely necessary)
Do a short testtrip and check if the trip data is sent to the test software(absolutely necessary)

Depending on the customers configuration::

private switch is connected and tested
driver identification is connected and tested
the buzzer - driver identification is working according the customers configuration

Documentation

After finishing your installation and tests you should send a Installation document to your customer/partner.

GPS-Manuals-Public